How to reload jbl column

On the modern market you can see many varieties of columns. Each of them requires an individual approach. In this article we will analyze the situation in which the jbl model has ceased to respond to requests: consider the options for troubleshooting, as well as ways to reset it.

The jbl column hangs and does not turn off - what to do?

Despite the fact that the presented version of the design is not cheap, it is still peculiar to acquire faults during operation. But this, of course, does not mean that there is one way out. Sometimes it is enough to find out the source of the problem and fix it in a timely manner. Therefore, if you notice that the equipment does not respond to yours, then you should follow the recommendations below:

• It often helps to disconnect the battery and hold the equipment in such a state for some time. But it may be that after this work will not be carried out. In this case, the problem lies directly in the power controller.
• In addition, waiting sometimes helps. But first it is worth waiting for the unit to squander its entire charge. After that, re-charge and try to activate the column again.
• If the above steps do not help, then you will most likely have to update the software. An effective method is also a complete discharge. For this it is necessary to detect a small hole on the surface of the invention. After that you should arm yourself with a thin needle or another similar object. And gently insert it into the connector a few millimeters. There may be a distinctive sound.

ATTENTION. It is recommended to do the procedure as carefully as possible, since at this stage it is fairly easy to damage the inner surface.

• Thus, all possible settings will be reset to factory settings. And after re-inclusion will be available to the original characteristics.

IMPORTANT. Presented goal can be achieved not only in one way. It is also possible to do this by using certain combinations. That is, at the same time it is necessary to press both the “volume” button and “play” button. Retention time varies from three seconds. After that, the result will be similar to the previous one.

• Perhaps quite a rare case, but it can also happen: the oxidation of the shutdown button. Many sellers can tell a potential buyer that the device is not only protected from moisture, but also waterproof. However, this is often untrue. Therefore, it is possible that the user may not specifically expose jbl to various liquids. Due to this, internal contacts deteriorate, and the invention fails.
• In extreme cases, you can enable a special mode DFU. Due to it, the firmware update will be activated. To do this, delay the sequence of buttons, consisting of "connect" and "volume". Then it remains to wait at least 10 seconds. To disable the named mode, you will have to attach the design to the charging and carry out a similar manipulation (pressing the same two parts).

Of course, if you are unsure of the veracity of your actions and conjectures, it is better not to commit serious actions right away. It is advisable to contact the service center in time or call the jbl manufacturer’s hotline.

How to reset jbl charge column

Make it as simple as possible using only two buttons. Detailed instructions are presented below:

1. Take the device and find on it the call and power button. And the combination should be executed simultaneously.
2. The wait time can reach 30 seconds, therefore, you must wait.
3. After that, the existing indicator (usually red) should go out.
4. To re-enable the equipment, you need to press a certain button to activate. Accordingly, the blue icon will continue to burn.

Thus, almost every model has a similar algorithm of actions for rebooting. This sequence can be used with different columns from the manufacturer jbl.