How to turn on the cooler in the cooler: rules for using the cooler

There are coolers in many offices, but not everyone knows how to use the device correctly and turn on the refrigerator mode on it. It is necessary to follow all the manufacturer's recommendations for the device to work longer.

Cooler connection

What to consider before installing:

Do not place the unit near heating radiators or things that heat up.
If the device was stored in a cold place, or it was transported in the winter, before connecting it to the network, it must be unpacked and stored for several hours in the room.
If during transportation the device was in the wrong position, it must be put in the correct position for a day, before use. Devices in which there is a compressor should be transported vertically, since there is a risk of loss of fluid that cools the water (freon).
You can’t pour bad water into the cooler, the one that is recruited from the tap or the one that contains carbon dioxide.
The recommended temperature of the room where the cooler will be located is from 10 to 38 degrees, and humidity is less than 10 percent.
The cooler should be at a distance of 20 cm from the wall or other objects.
The cooler must be closed from the sun.
Do not store the device in freezing temperatures. If it was in a frost for some time, it must be turned off for several hours.
Do not place foreign objects under the apparatus.
It is not recommended to change the position of the device (it should always be vertical).
If you transport the device or store it in a room that is not heated, you must first pour out all the liquid that is inside the system. All switches are set to position A. Disconnect it from the outlet. Open the taps and drain the water. If it is very hot, wait until it cools. Open the valve so that the water begins to drain (it is located on the rear wall of the cooler, either in the center of the panel or on the edge).

Note! Before turning on the device, you need to put a container filled with water.

Turn on the refrigerator in the cooler

If a red light is lit next to the hot water tap, it means that the water temperature has cooled to 85 degrees, and the cooler is now heating it. With such water, you can’t make good tea or coffee.

If a green light is lit next to the cold water tap, it means that the water temperature is very low, and now it is heating up to 8 degrees. If you try to pour water now, it will be too cold and unusable if a person has a sore throat. To get a good temperature, it is better not to use the cooler several times in a row. It is recommended to pour 2 glasses at a time.

What else to consider before using

Remove the sticker from the container. If this is not done, it will fall into the crane, and you will have to call the master for repair. You will also have to get rid of dirt and germs that have fallen into the water.
Wipe the water intake needle with a wet cloth.
The tank can only be installed vertically. It is installed with a light touch. You can not hit her. Then you will need to wait until water is poured into the tank. It takes a few minutes.
A new bottle cannot be taken with dirty hands.
Turn on hot water and wait for the jet to flow. Collect about a glass of water (this is necessary to remove air from the system).
You can connect the cooler to an outlet. If you turned on the device, and the system did not have time to fill up, protection will turn on. In this case, you will have to contact the service center.
Turn on the toggle switch (it is located on the panel). If 2-3 bulbs turned on in front, then the cooler turned on successfully and started to warm up the water. Hot will warm up to 95 degrees, cold to 12. But before using the device, you need to wait until all the lights go out.
If the refrigerator installed in the cooler has not been used before, you need the camera to work for a couple of hours, after which it can be used.
To turn off the heating, be sure to press the switch. Do not pull it out of the socket.