To use the game console, you must connect the joystick. To do this is very simple, just turn on both devices and perform a series of actions by pressing certain keys.
What you need to connect
To connect, you only need a console and a gamepad. We need to press the appropriate buttons to turn it on. But remember, if there are no drivers on the console, they must first be installed. And wireless models will not work without a receiver that plugs into a USB connector. Wireless devices need bluetooth. The receiver can be bought in the same store as the joystick.
What problems may arise
The most common problem - the console does not perceive a gamepad. Try the following:
- Pull the cable out of the USB connector and put it back. Check port, plug and cable for external damage. But the problem may concern the inside of the wire, for example, the insulation layer is damaged or the contacts are stuck. In such cases, contact the service center.
- If the connection is wireless, try reconnecting the device. Make sure the bluetooth is turned on and working.
- Reboot the console.
- Reboot the gamepad by pressing the Xbox key and holding it for 5 seconds. Turn on the device by pressing this button again.
If all of the above methods do not help, there is a high probability of damage to the cable or port. Then a repair is needed. In this case, you must take the joystick to a service center or buy a new one. If you understand the structure of the gamepad, you can do it yourself.
Reference! Another problem - the joystick turned on, but it does not work. This trouble is rare. We need to reconnect. If the connection is wireless, it is highly likely that some device is causing interference (this applies to Wi-Fi and Bluetooth devices). Use the joystick away from them.
The last problem is that the gamepad is out of date. Some modern games do not support older versions of gamepads. Unfortunately, repair is not possible, it remains only to buy modern equipment.
There are some notes to consider:
- One console can work no more than with 8 joysticks at a time.
- You must assign a joystick specifically for the user who will hold it (something like an account).
Connect the joystick to the xbox one: step by step
To connect the gamepad to the console, do the following:
- Turn on the prefix.
- We insert batteries or accumulators into the joystick. To do this, open the lid on the rear panel.
- Turn on the joystick by pressing the key Hold it for 3 seconds. The key is located in the middle of the top of the device.
- The Xbox button should start flashing. This indicates that the device is turned on.
- If the joystick does not turn on, check the batteries. Perhaps they have already sat down. Also make sure that you have installed them correctly. Try using batteries on another device. Same thing with the battery.
- Now we press the connection button on the console. It is not necessary to clamp it. For Xbox One X and Xbox One S versions, the key is located on the front panel on the right side, under the power key. She is small and round. And for the Xbox One version, the key is located on the side panel at the corner (where the drive is).
- Now you need to connect the gamepad. To do this, press the round key on the top panel (if you hold the device in your hands). You need to hold down the key and hold for about 20 seconds. You must wait for the Xbox button on the joystick to flash several times. This means that the prefix is being searched. While the joystick is connected, the Xbox key will light.
- If we need to connect augmented gamepads, just repeat these steps with them.
Using an adapter cable and a USB connector
Most types of consoles have a USB port for wired devices. It’s easy to connect them, you just need to insert the USB plug into the corresponding connector. In such cases, the gamepad is able to work without batteries and batteries.
Connecting a gamepad to the console is very simple. You need to check what type of connection is used, press the appropriate keys, and if you encounter problems, try restarting the entire system.
Leave Your Comment